Jump to content
General Bug Report Guidelines - Please Read ×

K-Drive | Needlenose sets too far back


Melon_Wizard
 Share

Recommended Posts

Pictured below is the pre-build look of the board in the assemble menuub3ykkY.jpg

and this is the board in practice, recolored, and on the plains

4bShgAp.jpg

as shown the reactor and jet are out of place relative to the board in the use model, so the reactor clips through the board where it should hang off

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share

×
×
  • Create New...