Impossible tile in onslaught

[-Taps-]

I found a tile with only one enemy type and barely any spawns in the onslaught, there were never more than 10 enemies at a time on that tile, it instantly ruined my efficiency needless to say.

[MaruRama]

Got exact same in 3 last games wave 7th  twice - only like 10 Actient Healers and nothing else   and  a wave 9  a some random grenier like 5 of them  and nothing  - it is a bit hard to grab khora Bp from zone 8 when wave 7 is auto loos  ;)

Frame was Banshe Quake   so i would hit enemys even if they would spawn in walls or in lvl geometry - but nothing

Game mode: "casual Onslaught" 

[-Taps-]

yeah it seems like this happens whenever the enemy type on a tile is limited and not "common"

[MaruRama]

Well in case of Grenier  i think i found a Evil doer   -  Grenier "pinocio" Scraper  - when he shows in both mode - he shows only and in amount like 10 ~15  in whole zone - not big deal in zone 1  (you pass  to zone 2 with like 50 %~60%  ) but above 5 th is  auto game over  - my solution DE  pleas remove Pinochio he is bad boy and causes troubles ;) in case of other faction is "cthulhu one"  but no idea the name .... we killed it to fast

[-Dantos-]

I just had this as well, one of the Corpus tilesets, zone 8, only Ancients spawned, then the host left after we cleared it and I went through the portal and I got stuck in a host migration loop and had to hard quit the game to get out of it.

[MobyTheDuck]

This map in a run ender. Enemies spawn all over the place, mainly on the three side rooms and on the lower levels, and they dont know how to reach your or how to use stairs.

Dont helps that they messed up spawns since the last hotfix.

[ShadowRyker]

I can also confirm this, zone 11 in normal onslaught only spawns in a few ancients and that's it. A few runs of mine were lost immediately on Zone 11 because of the poor amount of enemies spawning.